Chapter 7 Wireless LAN Profiles
UAG CLI Reference Guide
66
The following table describes the commands available for SSID profile management. You must use
the
configure terminal
command to enter the configuration mode before you can use these
commands.
securityprofile
Assigns an existing security profile to the SSID profile. You may use 1-31
alphanumeric characters, underscores (
_
), or dashes (-), but the first character
cannot be a number. This value is case-sensitive.
macfilterprofile
Assigns an existing MAC filter profile to the SSID profile. You may use 1-31
alphanumeric characters, underscores (
_
), or dashes (-), but the first character
cannot be a number. This value is case-sensitive.
description2
Sets the description of the profile. You may use up to 60 alphanumeric
characters, underscores (
_
), or dashes (-). This value is case-sensitive.
Table 18
Input Values for General SSID Profile Commands (continued)
LABEL
DESCRIPTION
Table 19
Command Summary: SSID Profile
COMMAND
DESCRIPTION
show wlan-ssid-profile {
all |
ssid_profile_name
}
Displays the SSID profile(s).
all
: Displays all profiles for the selected operating mode.
ssid_profile_name
: Displays the specified profile for the
selected operating mode.
wlan-ssid-profile rename
ssid_profile_name1
ssid_profile_name2
Gives an existing SSID profile (
ssid_profile_name1
) a new
name (
ssid_profile_name2
).
[no] wlan-ssid-profile
ssid_profile_name
Enters configuration mode for the specified SSID profile. Use the
no
parameter to remove the specified profile.
bandselect check-sta-interval <1..60000>
Sets how often (in seconds) the AP checks and deletes old
wireless client data.
bandselect drop-authentication <1..16>
Sets how many authentication request from a client to a 2.4GHz
Wi-Fi network is ignored during the specified timeout period.
bandselect drop-probe-request <1..32>
Sets how many prob request from a client to a 2.4GHz Wi-Fi
network is ignored during the specified timeout period.
bandselect min-sort-interval <1..60000>
Sets the minimum interval (in seconds) at which the AP sorts the
wireless client data when the client queue is full.
bandselect mode {disable | force |
standard}
To improve network performance and avoid interference in the
2.4 GHz frequency band, you can enable this feature to use the 5
GHz band first. You should set 2.4GHz and 5 GHz radio profiles to
use the same SSID and security settings.
Note: The managed APs must be dual-band capable.
disable
: to turn off this feature.
force
: to have the wireless clients always connect to an SSID
using the 5 GHZ band. Connections to an SSID using the 2.4GHz
band are not allowed. It is recommanded you select this option
when the AP and wireless clients can function in either frequency
band.
standard
: to have the AP try to connect the wireless clients to
the same SSID using the 5 GHZ band. Connections to an SSID
using the 2.4GHz band are still allowed.
bandselect time-out-period <1..256>
Sets the timeout period (in seconds) within which the AP drops
the specified number of prob or authentication requests to a
2.4GHz Wi-Fi network.
Summary of Contents for UAG Series
