ZyXEL Communications UAG Series, Reference Manual

Page: 55 / 361

UAG CLI Reference Guide
55
C
H A P T E R
6
AP Management
This chapter shows you how to configure wireless AP management options on your UAG.
6.1 AP Management Overview
The UAG allows you to remotely manage all of the Access Points (APs) on your network. You can
manage a number of APs without having to configure them individually as the UAG automatically
handles basic configuration for you.
The commands in this chapter allow you to add, delete, and edit the APs managed by the UAG by
means of the CAPWAP protocol. An AP must be moved from the wait list to the management list
before you can manage it. If you do not want to use this registration mechanism, you can disable it
and then any newly connected AP is registered automatically.
6.2 AP Management Commands
The following table identifies the values required for many of these commands. Other input values
are discussed with the corresponding commands.
Table 12
Input Values for General AP Management Commands
LABEL DESCRIPTION
ap_mac
The Ethernet MAC address of the managed AP. Enter 6 hexidecimal pairs separated by
colons. You can use 0-9, a-z and A-Z.
ap_model
The model name of the managed AP, such as NWA5160N, NWA5560-N, NWA5550-N,
NWA5121-NI or NWA5123-NI.
slot_name
The slot name for the AP’s on-board wireless LAN card. Use either
slot1
or
slot2
. (The
NWA5560-N supports up to 2 radio slots.)
profile_name
The wireless LAN radio profile name. You may use 1-31 alphanumeric characters,
underscores(
_
), or dashes (-), but the first character cannot be a number. This value is
case-sensitive.
ap_description
The AP description. This is strictly used for reference purposes and has no effect on any
other settings. You may use 1-31 alphanumeric characters, underscores(
_
), or dashes
(-), but the first character cannot be a number. This value is case-sensitive.
sta_mac
The MAC address of the wireless client. Enter 6 hexidecimal pairs separated by colons.
You can use 0-9, a-z and A-Z.