Chapter 43 Content Filtering
UAG CLI Reference Guide
220
43.8 Content Filter URL Cache Commands
The following table lists the commands that you can use to view and configure your UAG’s URL
caching. You can configure how long a categorized web site address remains in the as well as view
those web site addresses to which access has been allowed or blocked based on the responses from
the external content filtering server. The UAG only queries the external content filtering database
for sites not found in the cache.
Use the
configure terminal
command to enter the configuration mode to be able to use these
commands. See
for details about the values you can input with these
commands.
no content-filter profile
filtering_profile
commtouch-url match {log}
Has the UAG not log attempted access to web pages that
match the CommTouch profile’s selected managed
categories.
no content-filter profile
filtering_profile
commtouch-url offline {log}
Has the UAG not log access to web pages if the
CommTouch external content filtering database is
unavailable.
no content-filter profile
filtering_profile
commtouch-url unrate {log}
Has the UAG not log access to web pages that the
CommTouch external web filtering service has not
categorized.
show content-filter profile [
filtering_profile]
Displays the specified content filtering profile’s settings or
the settings of all them if you don’t specify one.
Table 134
content-filter profile Commands Summary (continued)
COMMAND
DESCRIPTION
Table 135
content-filter url-cache Commands
COMMAND
DESCRIPTION
[no] content-filter cache-timeout
_timeout
Sets how long to keep a content filtering URL cache entry
before discarding it. The
no
command clears the setting.
show content-filter url-cache [all-category] [begin
url_cache_range
end
url_cache_range
] [_count]
Displays the contents of the content filtering URL cache. You
can specify a range and number of entries to display.
show content-filter url-cache
Displays the contents of the content filtering URL cache.
content-filter url-cache test
Enters the sub-command mode for testing whether or not a
web site is saved in the UAG’s database of restricted web
pages.
url
Tests whether or not a web site is saved in the UAG’s
database of restricted web pages.
exit
Leaves the sub-command mode.
Summary of Contents for UAG Series
