Chapter 41 SSL VPN
UAG CLI Reference Guide
207
41.2.2 Setting an SSL VPN Rule Tutorial
Here is an example SSL VPN configuration. The SSL VPN rule defines:
• Only users using the “tester” account can use the SSL VPN.
• The UAG will assign an IP address from 192.168.100.1 to 192.168.100.10 (defined in object “IP-
POOL”) to the computers which match the rule’s criteria.
• The UAG will assign two DNS server settings (172.16.1.1 and 172.16.1.2 defined in objects DNS1
and DNS2) to the computers which match the rule’s criteria.
• The SSL VPN users are allowed to access the UAG’s local network, 172.16.10.0/24 (defined in
object “Network1”).
• Users have to access the SSL VPN using a computer that complies with all the following criteria
(defined in object “EPS-1”):
• Windows XP is installed.
• TrendMicro PC-Cillin Internet Security 2007 is installed and activated.
[no] eps periodical-check
<1..1440>
Sets the number of minutes to have the UAG repeat the endpoint security
check at a regular interval. The
no
command disables this setting.
[no] network-extension {activate |
ip-pool
address_object
| 1st-dns
{
address_object
|
ip
} | 2nd-dns
{
address_object
|
ip
} | 1st-wins
{
address_object
|
ip
} | 2nd-wins
{
address_object
|
ip
} | network
address_object
}
Use this to configure for a VPN tunnel between the authenticated users and
the internal network. This allows the users to access the resources on the
network as if they were on the same local network.
ip-pool
: specify the name of the pool of IP addresses to assign to the
user computers for the VPN connection.
Specify the names of the DNS or WINS servers to assign to the remote
users. This allows them to access devices on the local network using
domain names instead of IP addresses.
network
: specify a network users can access.
[no] network-extension traffic-
enforcement
Forces all SSL VPN client traffic to be sent through the SSL VPN tunnel. The
no
command disables this setting.
[no] user
user_name
Specifies the user or user group that can use the SSL VPN access policy.
sslvpn policy move <1..16> to <1..16>
Moves the specified SSL VPN access policy to the number that you
specified.
sslvpn no connection username
user_name
Terminates the user’s SSL VPN connection and deletes corresponding
session information from the UAG.
no sslvpn policy
profile_name
Deletes the specified SSL VPN access policy.
sslvpn policy rename
profile_name
profile_name
Renames the specified SSL VPN access policy.
show workspace application
Displays the SSLVPN resources available to each user when logged into
SSLVPN.
show workspace cifs
Displays the shared folders available to each user when logged into
SSLVPN.
Table 128
SSL VPN Commands
COMMAND
DESCRIPTION
Summary of Contents for UAG Series
