ZyXEL Communications STB-1003, User Manual

Page: 21 / 98

Chapter 1 Introducing the STB
STB-1003 User’s Guide
21
The following table describes the connections and controls on the front and rear panels.
1.3 Resetting the STB
"
If you reset the STB, all configuration changes will be lost.
REMOTE Blinking Green The Infra-red receiver on the front of the STB is
receiving signals from the remote control.
Off The Infra-red receiver on the front of the STB is not
receiving signals from the remote control.
Table 2 Connections and Controls
ITEM DESCRIPTION
Card Slot Use this to connect a Smart Card, supplied by your service provider.
USB Use the USB ports to connect a USB keyboard or joystick.
Reset Press this to reboot the STB. The configuration remains unchanged.
On / Standby Use this button to switch the STB on from standby, and vice versa. Standby
uses less power, and allows you to start up the STB quickly.
POWER Connect this port to a suitable power supply using the provided adaptor.
ON / OFF Use this switch to turn the STB on or off.
ETHERNET Use this Ethernet port to connect the STB to your Internet access device or
network.
HDMI Use this port to connect your STB to a High Definition Multimedia Interface
(HDMI) television.
S/PDIF (Optical) Use this port to connect the STB to a S/PDIF (Sony / Philips Digital
Interface Format) audio device using an optical connector.
S-Video Use this to connect the STB to your TV’s S-Video connector.
The S-Video connector does not carry audio. You must also connect your
TV to one of the STB’s audio connectors.
Composite Video Use this to connect the STB to your TV’s analog video input (usually
colored yellow).
The composite video connector does not carry audio. You must also
connect your TV to one of the STB’s audio connectors.
S/PDIF Use this port to connect the STB to a S/PDIF (Sony / Philips Digital
Interface Format) audio device using an RCA connector.
Analog Audio Use these to connect the STB to your audio device’s analog audio inputs.
The red RCA connector carries the stereo audio signal (right channel).
The white RCA connector carries the stereo audio signal (left channel).
Component Video Use these to connect the STB to a television with YPbPr connectors.
Each connector is color-coded. Connect it to the socket on your TV that has
the same color.
YPbPr connectors do not carry audio. You must also connect your TV to
one of the STB’s audio connectors.
Table 1 LEDs (continued)
LED STATUS DESCRIPTION