ZyXEL Communications SAM1316-22, User Manual

Page: 441 / 464

Chapter 62 Troubleshooting
SAM1316-22 User’s Guide
441
The SAM1316-22 is now reinitialized with a default configuration file including the
default user name of “admin” and the default password of “1234”.
62.13.2 Uploading the Default Configuration File
If you forget your password or cannot access the SAM1316-22, you will need to
reload the factory-default configuration file. Uploading the factory-default
configuration file replaces the current configuration file with the factory-default
configuration file. This means that you will lose all previous configurations and the
speed of the console port will be reset to the default of 9600 bps with 8 data bit,
no parity, one stop bit and flow control set to none. The password will also be
reset to “1234” and the IP address to 192.168.1.1.
Note: Uploading the factory default configuration file erases the SAM1316-22’s entire
configuration.
Obtain the default configuration file, unzip it and save it in a folder. Use a console
cable to connect a computer with terminal emulation software to the SAM1316-
22’s console port. Turn the SAM1316-22 off and then on to begin a session. When
you turn on the SAM1316-22 again you will see the initial screen. When you see
the message
Press any key to enter Debug Mode within 3 seconds
press any
key to enter debug mode.
To upload the configuration file, do the following:
1
Type
atlc
after the
Enter Debug
Mode message.
2
Wait for the
Starting XMODEM upload
message before activating XMODEM upload
on your terminal.
3
This is an example Xmodem configuration upload using HyperTerminal. Click
Transfer, then Send File to display the following screen.
Figure 273 Example Xmodem Upload
Type the configuration file's location, or click Browse to search for it. Choose the
1K Xmodem protocol. Then click Send.