ZyXEL Communications SAM1316-22, User Manual

Page: 417 / 464

Chapter 60 Virtual Channel Management
SAM1316-22 User’s Guide
417
60.7.8 RPVC Route Set Command
Syntax:
ras> shdsl rpvc route set <port number> <vpi> <vci> <ip>/<netmask>
where
This command adds a domain for 2684 routed mode traffic. The domain includes
the subscriber’s LAN IP addresses.
Note: You must use the
rpvc gateway set
and the
rpvc set
commands before you
use the
rpvc route set
command.
The following example adds a domain for a CPE device is connected to DSL port 1
on the SAM1316-22 and the 2684 routed mode traffic is to use the PVC identified
by VPI 8 and VCI 35. The CPE device’s LAN IP address is 10.10.10.10 and uses a
subnet mask of 255.255.255.0. This includes the CPE device’s LAN IP addresses
and the IP addresses of the LAN computers.
60.7.9 RPVC Route Show Command
Syntax:
ras> shdsl rpvc route show <portlist>
<port number> =
The port of the RPVC. Specify a single DSL port <1>.
<vpi> =
The VPI of the RPVC.
<vci> =
The VCI of the RPVC.
<ip> =
The subscriber’s CPE LAN IP address in dotted decimal
notation.
/<netmask> =
The bit number of the subnet mask of the subscriber’s
IP address. To find the bit number, convert the subnet
mask to binary and add all of the 1’s together. Take
“255.255.255.0” for example. 255 converts to eight 1’s
in binary. There are three 255’s, so add three eights
together and you get the bit number (24).
Figure 255 RPVC Route Set Command Example
ras> shdsl rpvc route set 1 8 35 10.10.10.1/24