ZyXEL Communications SAM1316-22, User Manual

Page: 385 / 464

SAM1316-22 User’s Guide
385
C
H A P T E R
5 9
DSL Commands
This chapter describes some of the commands that allow you to configure and
monitor the DSL ports.
59.1 DSL Port Commands
Use these commands to configure the DSL ports. See Chapter 13 on page 91 for
background information on DSL and SHDSL.
59.1.1 DSL Port Show Command
Syntax:
ras> shdsl show [portlist]
where
This command shows the activation status, DSL mode, maximum upstream and
downstream rate settings, and DSL profile of each DSL port. It also provides
subscriber information for the port.
The following example displays information on DSL port 1.
[portlist] =
You can specify a single DSL port <1>, all DSL ports
<*> or a list of DSL ports <1,3,5>. You can also include
a range of ports <1,5,6~8>.
Figure 220 DSL Port Show Command Example
ras> shdsl show 1
port enable mode min/max rate profile
---- ------ ---- ------------- -------------------------------
1 V stuc 192/ 2304 DEFVAL
Subscriber Info:
port name tel
---- -------------------------------- ----------------
1 - -