ZyXEL Communications SAM1316-22, User Manual

Page: 359 / 464

Chapter 53 PPPoE Intermediate Agent Commands
SAM1316-22 User’s Guide
359
53.1.5 PPPoE Intermediate Agent Info Command
Syntax:
ras> switch poeagent info <vid>|all <description>
where
This command specifies the extra information the SAM1316-22 adds to PADI and
PADR packets in the specified VLAN or in all VLANs, if the PPPoE intermediate
agent is enabled.
Note: Before you can configure PPPoE intermediate agent information, you must first
create a entry using the
poeagent set
command.
The following example sets the switch to add “testing” to PADI and PADR packets
on VLAN 100.
53.1.6 PPPoE Intermediate Agent Set Command
Syntax:
ras> switch poeagent set <vid>
<vid>|all =
The ID of the VLAN to which to apply the setting. Type
all
to apply the setting to all VLAN.
<description> =
The PPPoE line information the switch is to add to PPPoE
discover packets from the specified VLAN or from all
VLAN. Enter a description (up to 24 alphanumerical
characters).
Figure 194 PPPoE Intermediate Agent Info Command Example
ras> switch poeagent info 100 testing
ras> switch poeagent show
vid enable info
---- ------ -----------------------------
0 -
100 V testing
101 -
102 -
Note: vid 0 is the default agent.