ZyXEL Communications SAM1316-22, User Manual

Page: 354 / 464

Chapter 52 IGMP Commands
SAM1316-22 User’s Guide
354
This command displays the current multicast VLAN settings. In the state column,
“-” indicates the multicast VLAN is not active while “V” indicates the multicast
VLAN is active.
Figure 191 Multicast VLAN Show Command Example
52.8.6 Multicast VLAN Group Set Command
Syntax:
ras> switch igmpsnoop mvlan group set <vid> <index> <start-mcast-ip> <end-
mcast-ip>
where
This command creates a multicast VLAN group. The following example creates a
multicast VLAN with VID 10 and group index 1. The multicast address range is
224.224.224.1 ~ 224.224.224.10.
Figure 192 Multicast VLAN Group Set Command Example
52.8.7 Multicast VLAN Group Delete Command
Syntax:
ras> switch igmpsnoop mvlan group delete <vid> <index>
where
ras> switch igmpsnoop mvlan show 1
vid name F:fixed X:forbidden U:untag T:tag
---- ---------------- ----------------------------------------
<vid> =
The multicast VLAN ID [1 – 4094].
<index> =
1..16; a unique number for this setting.
<start-mcast-
ip>
=
Start of the multicast IP address range.
<end-mcast-ip> =
End of the multicast IP address range.
ras> switch igmpsnoop mvlan group set 10 1 224.224.224.1
224.224.224.10
<vid> =
The multicast VLAN ID [1 – 4094].
<index> =
1..16; a unique number for this setting.