ZyXEL Communications SAM1316-22, User Manual

Page: 325 / 464

Chapter 50 IEEE 802.1Q Tagged VLAN Commands
SAM1316-22 User’s Guide
325
50.4.2 VLAN PVID Command
Syntax:
ras> switch vlan pvid <portlist> <pvid>
where
This command sets a default VLAN ID for all untagged packets that come in
through the specified port.
The following example sets the default VID of port 1 to 200.
50.4.3 VLAN Priority Command
Syntax:
ras> switch vlan priority <portlist> <priority>
where
This command sets the priority of incoming frames with an IEEE 802.1Q VLAN tag.
The following example sets a priority of three for frames (with an IEEE 802.1Q
VLAN tag) that come in on DSL port 2.
<portlist> =
You can specify a single port <1>, all ports <*> or a list
of ports <1,3,enet1>. You can also include a range of
ports <1,5,6~8,enet1>.
<pvid> =
The VLAN ID. Valid parameter range = [1 – 4094].
Figure 153 VLAN PVID Command Example
ras> switch vlan pvid 1 200
<portlist> =
You can specify a single port: <1>, all ports: <*>, a list
of ports: <1,3,enet1>, you can also include a range of
ports: <1,5,6~8,enet1>.
<priority> =
This is the priority value (0 to 7) to use for incoming
frames with an IEEE 802.1Q VLAN tag.
Figure 154 VLAN CPU Set Command Example
ras> switch vlan priority 2 3