ZyXEL Communications SAM1316-22, User Manual

Page: 233 / 464

Chapter 35 Access Control
SAM1316-22 User’s Guide
233
35.4 SNMP Screen
To open this screen, click Advanced Application, Access Control, SNMP.
Figure 112 SNMP
The following table describes the labels in this screen.
Table 81 SNMP
LABEL DESCRIPTION
Up Click Up to go back to the previous screen.
Get Community Enter the get community, which is the password for the incoming Get-
and GetNext- requests from the management station.
Set Community Enter the set community, which is the password for incoming Set-
requests from the management station.
Trap Community Enter the trap community, which is the password sent with each trap
to the SNMP manager.
Trap Destination
1~4 Enter the IP address of a station to send your SNMP traps to.
Port Enter the port number upon which the station listens for SNMP traps.
Trusted Host A “trusted host” is a computer that is allowed to use SNMP with the
SAM1316-22.
0.0.0.0 allows any computer to use SNMP to access the SAM1316-22.
Specify an IP address to allow only the computer with that IP address
to use SNMP to access the SAM1316-22.
Apply Click Apply to save your changes to the SAM1316-22’s volatile
memory. The SAM1316-22 loses these changes if it is turned off or
loses power, so use the Config Save link on the navigation panel to
save your changes to the non-volatile memory when you are done
configuring.
Cancel Click Cancel to begin configuring this screen afresh.