ZyXEL Communications SAM1316-22, User Manual

Page: 195 / 464

Chapter 28 2684 Routed Mode
SAM1316-22 User’s Guide
195
28.2 2684 Routed PVC Screen
Use this screen to configure PVCs for 2684 routed mode traffic.
To open this screen, click Advanced Application, 2684 Routed Mode.
Figure 94 2684 Routed PVC
The following table describes the labels in this screen.
Table 64 2684 Routed PVC
LABEL DESCRIPTION
Routed Domain Click Routed Domain to open this screen where you can configure
domains for 2684 routed mode traffic (see
Section 28.3 on page
196 ).
RPVC ARP Proxy Click RPVC ARP Proxy to go to the screen where you can view the
Address Resolution Protocol table of IP addresses of CPE devices
using 2684 routed mode and configure how long the device is to store
them (see
Section 28.4 on page 198 ).
Routed Gateway Click Routed Gateway to go to the screen where you can configure
gateway settings (see
Section 28.5 on page 199 ).
Port Use this drop-down list box to select a port for which you wish to
configure settings.
Gateway IP Enter the IP address of the gateway to which you want to send the
traffic that the system receives from this PVC. Enter the IP address in
dotted decimal notation.
VPI Type the Virtual Path Identifier for this routed PVC.
VCI Type the Virtual Circuit Identifier for this routed PVC.
IP Enter the subscriber’s CPE WAN IP address in dotted decimal
notation.
NetMask The bit number of the subnet mask of the subscriber’s WAN IP
address. To find the bit number, convert the subnet mask to binary
and add all of the 1’s together. Take “255.255.255.0” for example.
255 converts to eight 1’s in binary. There are three 255’s, so add
three eights together and you get the bit number (24).
Make sure that the routed PVC’s subnet does not include the
SAM1316-22’s IP address.