ZyXEL Communications SAM1316-22, User Manual

Page: 130 / 464

Chapter 16 G.bond
SAM1316-22 User’s Guide
130
16.2 G.bond Setup Screen
Use this screen to bond one or more ports into a logical link.
To open this screen, click Basic Setting > G.bond.
Figure 61 Basic Setting > G.bond
The following table describes the labels in this screen.
Table 31 Basic Setting > G.bond
LABEL DESCRIPTION
G.bond Status Click G.bond Status to look at the status of each port in each bond
(see
Section 16.2.1 on page 131 ).
Index This is the number of the bond. Click a profile’s index number to edit
the profile. You cannot edit the DEFVAL profile.
Bond Name
(STUC) This is the name of the bond.
SID This is the length of the sequence ID used in this bond.
US/DS (kbps) This is the maximum upstream bandwidth and maximum downstream
bandwidth available through this bond. This is calculated from the
maximum rate available through each port.
Delete Select the check box for one or more bonds, and click Delete to
remove the selected bond(s).
Cancel Select this to clear the fields in this screen without saving any
changes.
Bond Name Enter the name of the bond. You can use up to 31 English keyboard
characters; double quotation marks (“) and spaces are not allowed.