ZyXEL Communications Prestige 661H Series, User Manual

Page: 403 / 547

Prestige 661H/HW Series User’s Guide
403 Chapter 42 VPN/IPSec Setup
42.3 IPSec Setup
Select Edit in the Select Command field; type the index number of a rule in the Select Rule
field and press [ENTER] to edit the VPN using the menu shown next.
Note: You must also configure menu 27.1.1.1 or menu 27.1.1.2 to fully configure and
use a VPN.
Figure 262 Menu 27.1.1 IPSec Setup
The following table describes the fields in this menu.
Menu 27.1.1 – IPSec Setup
Index= 1 Name= Taiwan
Active= Yes Keep Alive= No Nat Traversal= No
Local ID type= IP Content:
My IP Addr= 0.0.0.0
Peer ID type= IP Content:
Secure Gateway Address= zw50test.zyxel.com.tw
Protocol= 0 DNS Server= 0.0.0.0
Local: Addr Type= SINGLE
IP Addr Start= 1.1.1.1 End/Subnet Mask= N/A
Port Start= 0 End= N/A
Remote: Addr Type= SUBNET
IP Addr Start= 4.4.4.4 End/Subnet Mask= 255.255.0.0
Port Start= 0 End= N/A
Enable Replay Detection = No
Key Management= IKE
Edit Key Management Setup= No
Press ENTER to Confirm or ESC to Cancel:
Table 138 Menu 27.1.1 IPSec Setup
FIELD DESCRIPTION
Index This is the VPN rule index number you selected in the previous menu.
Name Enter a unique identification name for this VPN rule. The name may be up to 32
characters long but only 10 characters will be displayed in Menu 27.1 - IPSec
Summary .
Active Press [SPACE BAR] to choose either Yes or No . Choose Yes and press [ENTER] to
activate the VPN tunnel. This field determines whether a VPN rule is applied before a
packet leaves the firewall.