ZyXEL Communications Prestige 642M series, User Manual

Page: 49 / 86

Prestige 642M Series ADSL Bridge
Filter Configuration 5-9
Figure 5-6 Example Filter Rules Summary - Menu 21.1
After you create the filter set you must apply it.
5.5 Applying a Filter
This section shows you where to apply the filter(s) after you design it (them).
5.5.1 Remote Node Filters
Go to Menu 11.1 (shown next) and enter the number(s) of the filter set(s) as appropriate. You can cascade
up to four filter sets by entering their numbers separated by commas.
Menu 21.1 - Filter Rules Summary
# A Type Filter Rules M m n
- - ---- --------------------------------------------------------------- - - -
1 Y Gen Off=128, Len=4, Mask=789abcde, Value=789abcde N D F
2 N
3 N
4 N
5 N
6 N
Enter Filter Rule Number (1-6) to Configure: 1
This shows you what you
configured in the previous
menu. M = N means an action can be taken
immediately. The action is to drop the
packet (
m = D ) if the action is matched and
to forward the packet immediately ( n = F ) if
the action is not matched no matter whether
there are more rules to be checked (there
aren’t in this example).