Chapter 1 Introduction
PM7516-R0 / PM7116-R0 User’s Guide
12
1.4.4 Reset Button
If you forget your password or cannot access the Web Configurator, you will need to use the
RESET
button on the rear panel of the device to reload the factory system configuration. This means that you
will lose all configurations that you had previously and the password will be reset to the default.
1
Make sure the
POWER
LED is on (not blinking).
2
Press the
RESET
button for more than 5 seconds or until the
POWER
LED begins to blink. Wait for the
POWER
LED to turn solid green. At this point, the device is reset to factory default settings.
Figure 6
Reset Button (PM7516-R0)
4
GND
5
GND
6
UPS status: Replace battery
7
UPS status: Low battery
8
NA
Table 4 UPS Port Pin Assignment (continued)
PIN UPS PORT
Summary of Contents for PM7116-R0
Page 7: ...7 PART I User s Guide...
Page 17: ...17 PART II Technical Reference...