ZyXEL Communications P8802T, User Manual

Page: 16 / 278

Chapter 1 Introducing the VDSL Router
Basic Home Station VDSL2 P8802T User’s Guide
16
1.6 3G WAN
The USB port (at the right side of the device when you
face to the front panel) allows you to wirelessly
connect to a 3G netowk to get Internet access by
attaching a 3G dongle. You must leave the VDSL
Router DSL or Ethernet WAN port unconnected and
attached a 3G dongle to use 3G as your WAN. You can
also heve the VDSL Router use the 3G WAN
connection as a backup. That means the VDSL Router
switches to the 3G wireless WAN connection after the
wired DSL or Ethernet WAN connection fails. The
VDSL Router automatically changes back to use the
wired DSL or Ethernet WAN connection when it is
available.
Figure 2 Internet Access Application: 3G WAN
1.7 The RESET Button
If you forget your password or cannot access the web configurator, you will need to use the RESET
button at the back of the device to reload the factory-default configuration file. This deletes all your
and the password will be reset to “1234”.
1
Make sure the Power LED is green and on (not blinking and not red or flashing red).
2
To set the device back to the factory default settings, press the RESET button for ten seconds or
until the Power LED begins to blink and then release it. When the Power LED begins to blink, the
defaults have been restored and the device restarts.
Note: The default username and password are on the label on the bottom of the Device.