ZyXEL Communications P-791R, User Manual

Page: 186 / 358

Chapter 22 Remote Node Setup
P-791R v2 User’s Guide
186
Figure 105 Menu 11.1: Remote Node Profile (nodes 1-7)
The following table describes the labels in this menu.
Menu 11.1 - Remote Node Profile
Rem Node Name= MyISP Route= IP
Active= Yes Bridge= No
Encapsulation= PPPoE Edit IP/Bridge= No
Multiplexing= LLC-based Edit ATM Options= No
Service Name= Edit Advance Options= No
Incoming: Telco Option:
Rem Login= Allocated Budget(min)= 0
Rem Password= ******** Period(hr)= 0
Outgoing: Schedule Sets=
My Login= Nailed-Up Connection= No
My Password= ******** Session Options:
Authen= CHAP/PAP Edit Filter Sets= No
Idle Timeout(sec)= 0
Table 63 Menu 11.1: Remote Node Profile (nodes 1-7)
FIELD DESCRIPTION
Rem Node Name Enter the name of the ISP.
Active Select whether or not you want to use this Internet connection.
Encapsulation Select the type of encapsulation your ISP uses.
Multiplexing Select the method of multiplexing used by your ISP from the drop-down list.
Choices are VC or LLC .
Service Name (PPPoE only) Enter the service name provided by your ISP. Leave this field
blank if your ISP did not provide one.
Incoming This section is only enabled for PPPoA or PPPoE connections.
Rem Login Type the login name that this remote node will use to call your ZyXEL Device.
The login name and the Rem Password will be used to authenticate this node.
Rem Password Type the password used when this remote node calls your ZyXEL Device.
Outgoing This section is only enabled for PPPoA or PPPoE connections.
My Login Enter the user name provided by your ISP.
My Password Enter the password provided by your ISP.
Retype to Confirm Enter the password again.
Authen This field appears if you select PPPoE in the Encapsulation field. Select what
type of authentication your ISP uses. Select CHAP/PAP if you want the ZyXEL
Device to support both choices.
Route Press [SPACE BAR] and then [ENTER] to select IP to enable IP-based routing
to this remote node. This is not effective unless you enable IP-based routing in
the ZyXEL Device too. See Menu 1: General Setup in Section 18.1 on page
169 .
You should enable Route IP , Bridge , or both in this screen. If you disable
Route IP and Bridge , the device does not send traffic between the LAN ports
and remote node.