ZyXEL Communications P-662HW-63, User Manual

Page: 145 / 561

Prestige 662HW Series User’s Guide
145 Chapter 13 Firewalls
Information hiding prevents the names of internal systems from being made known via DNS
to outside systems, since the application gateway is the only host whose name must be made
known to outside systems.
Robust authentication and logging pre-authenticates application traffic before it reaches
internal hosts and causes it to be logged more effectively than if it were logged with standard
host logging. Filtering rules at the packet filtering router can be less complex than they would
be if the router needed to filter application traffic and direct it to a number of specific systems.
The router need only allow application traffic destined for the application gateway and reject
the rest.
13.2.3 Stateful Inspection Firewalls
Stateful inspection firewalls restrict access by screening data packets against defined access
rules. They make access control decisions based on IP address and protocol. They also
"inspect" the session data to assure the integrity of the connection and to adapt to dynamic
protocols. These firewalls generally provide the best speed and transparency, however, they
may lack the granular application level access control or caching that some proxies support.
See the
Stateful Inspection section for more information on Stateful Inspection.
Firewalls, of one type or another, have become an integral part of standard security solutions
for enterprises.
13.3 Introduction to ZyXEL’s Firewall
The Prestige firewall is a stateful inspection firewall and is designed to protect against Denial
of Service attacks when activated (in SMT menu 21.2 or in the web configurator). The
Prestige’s purpose is to allow a private Local Area Network (LAN) to be securely connected to
the Internet. The Prestige can be used to prevent theft, destruction and modification of data, as
well as log events, which may be important to the security of your network. The Prestige also
has packet filtering capabilities.
The Prestige is installed between the LAN and the Internet. This allows it to act as a secure
gateway for all data passing between the Internet and the LAN.
The Prestige has one DSL/ISDN port and one Ethernet LAN port, which physically separate
the network into two areas.
• The DSL/ISDN port connects to the Internet.
• The LAN (Local Area Network) port attaches to a network of computers, which needs
security from the outside world. These computers will have access to Internet services
such as e-mail, FTP, and the World Wide Web. However, “inbound access” will not be
allowed unless you configure remote management or create a firewall rule to allow a
remote host to use a specific service.