ZyXEL Communications P-660RU-T1 v3, User Manual, Page: 151 / 230

Chapter 22 Firmware
P-660RU-Tx v3 User’s Guide
151
1
Do not interrupt the file transfer process as this may PERMANENTLY
DAMAGE your device. When the Restore Configuration process is complete,
the device automatically restarts.
Restore Using FTP Session Example
Figure 72 Restore Using FTP Session Example
Refer to Section 22.1.1 on page 149 to read about configurations that disallow TFTP and FTP
over WAN.
FTP and TFTP Firmware and Configuration File Uploads
These examples show you how to upload firmware and configuration files.
1
Do not interrupt the file transfer process as this may PERMANENTLY
DAMAGE your device.
FTP is the preferred method for uploading the firmware and configuration. To use this feature,
your computer must have an FTP client. The following sections give examples of how to
upload the firmware and the configuration files.
FTP File Upload Command from the DOS Prompt Example
1 Launch the FTP client on your computer.
2 Enter “open”, followed by a space and the IP address of your device.
3 Press [ENTER] when prompted for a username.
4 Enter your password as requested (the default is “1234”).
5 Enter “bin” to set transfer mode to binary.
6 Use “put” to transfer files from the computer to the device, for example, “put
firmware.bin ras” transfers the firmware on your computer (firmware.bin) to the device
and renames it “ras”. Similarly, “put config.rom rom-0” transfers the configuration file
on your computer (config.rom) to the device and renames it “rom-0”. Likewise “get
rom-0 config.rom” transfers the configuration file on the device to your computer and
renames it “config.rom.” See earlier in this chapter for more information on filename
conventions.
ftp> put config.rom rom-0
200 Port command okay
150 Opening data connection for STOR rom-0
226 File received OK
221 Goodbye for writing flash
ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec.
ftp>quit