ZyXEL Communications P-660RU-T1 v3, User Manual, Page: 140 / 230

Chapter 19 CWMP
P-660RU-Tx v3 User’s Guide
140
19.2 The CWMP Setup Screen
Use this screen to configure your ZyXEL Device to be managed by a management server.
Click
Access Management > CWMP to display the following screen.
Figure 69 Access Management > CWMP
The following table describes the fields in this screen.
Table 40 Access Management > CWMP
LINK DESCRIPTION
CWMP Setup
CWMP Select Activated to allow the ZyXEL Device to be managed by a management server
or select Deactivated to not allow the ZyXEL Device to be managed by a
management server.
Login ACS Configure this part of the screen to log into the management server.
URL Type the IP address or domain name of the management server. If the ZyXEL Device
is behind a NAT router that assigns it a private IP address, you will have to configure a
NAT port forwarding rule on the NAT router.
User Name The user name is used to authenticate the ZyXEL Device when making a connection
to the management server. This user name on the management server and the ZyXEL
Device must be the same. Type a user name of up to 255 printable characters found
on an English-language keyboard. Spaces and characters such as @#$%^&*()_+ are
allowed.
Password The password is used to authenticate the ZyXEL Device when making a connection to
the management server. This password on the management server and the ZyXEL
Device must be the same. Type a password of up to 255 printable characters found on
an English-language keyboard.
Connection
Request
Use this part of the screen to allow the management server to connect to the ZyXEL
Device after a successful login.
Path Type the IP address or domain name of the ZyXEL Device. The management server
uses this path to verify the ZyXEL Device.