ZyXEL Communications P-660HW-DX, User Manual

Page: 184 / 364

Chapter 12 Static Route
P-660HW-Dx User’s Guide
184
Figure 102 Static Route
The following table describes the labels in this screen.
12.2.1 Static Route Edit
Select a static route index number and click Edit ( ). The screen shown next appears. Use
this screen to configure the required information for a static route.
Table 67 Static Route
LABEL DESCRIPTION
# This is the number of an individual static route.
Active Select the check box to activate this static route. Otherwise, clear the check box.
Name This is the name that describes or identifies this route.
Destination This parameter specifies the IP network address of the final destination. Routing is
always based on network number.
Gateway This is the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward
packets to their destinations.
Subnet Mask This is the IP subnet mask.
Modify Click the Edit icon to go to the screen where you can set up a static route on the
ZyXEL Device.
Click the Delete icon to remove a static route from the ZyXEL Device. A window
displays asking you to confirm that you want to delete the route.