ZyXEL Communications P-660HW-DX, User Manual

Page: 100 / 364

Chapter 6 LAN Setup
P-660HW-Dx User’s Guide
100
6.5 DHCP Setup
Use this screen to configure the DNS server information that the ZyXEL Device sends to the
DHCP client devices on the LAN.
Figure 52 DHCP Setup
The following table describes the labels in this screen.
Apply Click Apply to save the changes.
Cancel Click Cancel to begin configuring this screen afresh.
Table 27 Advanced LAN Setup (continued)
LABEL DESCRIPTION
Table 28 DHCP Setup
LABEL DESCRIPTION
DHCP Setup
DHCP If set to Server , your ZyXEL Device can assign IP addresses, an IP default
gateway and DNS servers to Windows 95, Windows NT and other systems that
support the DHCP client.
If set to
None , the DHCP server will be disabled.
If set to Relay , the ZyXEL Device acts as a surrogate DHCP server and relays
DHCP requests and responses between the remote server and the clients.
Enter the IP address of the actual, remote DHCP server in the Remote DHCP
Server field in this case.
When DHCP is used, the following items need to be set:
IP Pool Starting
Address
This field specifies the first of the contiguous addresses in the IP address pool.
Pool Size This field specifies the size, or count of the IP address pool.
Remote DHCP
Server
If Relay is selected in the DHCP field above then enter the IP address of the
actual remote DHCP server here.
DNS Server