ZyXEL Communications P-660HN-TxA, User Manual

Page: 109 / 324

Chapter 8 Wireless LAN
P-660HN-TxA User’s Guide
109
8.2.4 WPA(2) Authentication
Use this screen to configure and enable WPA or WPA2 authentication. Click the
Wireless LAN link under Network to display the AP screen. Select WPA, WPA2
or WPAMixed from the Security Mode list.
Figure 47 Network > Wireless LAN > AP: WPA(2)
The following table describes the wireless LAN security labels in this screen.
Table 30 Network > Wireless LAN > AP: WPA(2)
LABEL DESCRIPTION
Security Mode Choose WPA or WPA2 from the drop-down list box.
WPA Compatible This check box is available only when you select WPA2-PSK or WPA2
in the Security Mode field.
Select the check box to have both WPA-PSK and WPA wireless clients
be able to communicate with the ZyXEL Device even when the ZyXEL
Device is using WPA2-PSK or WPA2.
ReAuthentication
Timer Specify how often wireless stations have to resend usernames and
passwords in order to stay connected. Enter a time interval between
10 and 9999 seconds.
Note: If wireless station authentication is done using a RADIUS
server, the reauthentication timer on the RADIUS server has
priority.
Idle Timeout The ZyXEL Device automatically disconnects a wireless station from
the wired network after a period of inactivity. The wireless station
needs to enter the username and password again before access to the
wired network is allowed.
WPA Group Key
Update Timer The Group Key Update Timer is the rate at which the AP (if using
WPA(2)-PSK key management) or RADIUS server (if using WPA(2)
key management) sends a new group key out to all clients. The re-
keying process is the WPA(2) equivalent of automatically changing the
WEP key for an AP and all stations in a WLAN on a periodic basis.