ZyXEL Communications P-660HN-F1A, User Manual

Page: 326 / 430

Chapter 22 Tools
P-660HN-F1A User’s Guide
326
UNIX, use “get” to transfer from the device to the computer, “put” the other way
around, and “binary” to set binary transfer mode.
TFTP Upload Command Example
The following is an example TFTP command:
tftp [-i] host put firmware.bin ras
Where “i” specifies binary image transfer mode (use this mode when transferring
binary files), “host” is the device’s IP address, “put” transfers the file source on
the computer (firmware.bin – name of the firmware on the computer) to the file
destination on the remote host (ras - name of the firmware on the device).
Commands that you may see in GUI-based TFTP clients are listed earlier in this
chapter.
Using the FTP Commands to Back Up Configuration
1
Launch the FTP client on your computer.
2
Enter “
open
”, followed by a space and the IP address of your P-660HN-F1A.
3
Press [ENTER] when prompted for a username.
4
Enter your password as requested (the default is “1234”).
5
Enter “
bin
” to set transfer mode to binary.
6
Use “
get
” to transfer files from the P-660HN-F1A to the computer, for example,
“
get rom-0 config.rom
” transfers the configuration file on the P-660HN-F1A to
your computer and renames it “
config.rom
”. See earlier in this chapter for more
information on filename conventions.
7
Enter “
quit
” to exit the ftp prompt.