ZyXEL Communications P-660HN-F1A, User Manual

Page: 282 / 430

Chapter 18 Remote Management
P-660HN-F1A User’s Guide
282
Use this screen to specify which interfaces allow FTP access and from which IP
address the access can come. To change your P-660HN-F1A’s FTP settings, click
Advanced > Remote MGMT > FTP. The screen appears as shown.
Figure 122 Advanced > Remote Management > FTP
The following table describes the labels in this screen.
18.5 The SNMP Screen
Simple Network Management Protocol is a protocol used for exchanging
management information between network devices. Your P-660HN-F1A supports
SNMP agent functionality, which allows a manager station to manage and monitor
the P-660HN-F1A through the network. The P-660HN-F1A supports SNMP version
Table 86 Advanced > Remote Management > FTP
LABEL DESCRIPTION
Port You may change the server port number for a service, if needed.
However, you must use the same port number in order to use that
service for remote management.
Access Status Select the interface(s) through which a computer may access the P-
660HN-F1A using this service.
Secured Client
IP A secured client is a “trusted” computer that is allowed to communicate
with the P-660HN-F1A using this service.
Select All to allow any computer to access the P-660HN-F1A using this
service.
Choose Selected to just allow the computer with the IP address that
you specify to access the P-660HN-F1A using this service.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.