ZyXEL Communications P-660HN-F1A, User Manual

Page: 27 / 430

Chapter 1 Introducing the P-660HN-F1A
P-660HN-F1A User’s Guide
27
Refer to the Quick Start Guide for information on hardware connections.
1.6 The RESET Button
If you forget your password or cannot access the web configurator, you will need
to use the RESET button at the back of the device to reload the factory-default
configuration file. This means that you will lose all configurations that you had
previously and the password will be reset to “1234”.
1.6.1 Using the Reset Button
1
Make sure the POWER LED is on (not blinking).
2
To set the device back to the factory default settings, press the RESET button for
ten seconds or until the POWER LED begins to blink and then release it. When the
POWER LED begins to blink, the defaults have been restored and the device
restarts.
1.7 The WPS/WLAN Button
You can use the WPS/WLAN button on the back of the device to turn the wireless
LAN off or on. You can also use it to activate WPS in order to quickly set up a
wireless network with strong security.
INTERNET Green On The P-660HN-F1A has an IP connection but no traffic.
Your device has a WAN IP address (either static or
assigned by a DHCP server), PPP negotiation was
successfully completed (if used) and the DSL connection
is up.
Blinking The P-660HN-F1A is sending or receiving IP traffic.
Off The P-660HN-F1A does not have an IP connection.
Red On The P-660HN-F1A attempted to make an IP connection
but failed. Possible causes are no response from a DHCP
server, no PPPoE response, PPPoE authentication failed.
Table 1 LED Descriptions
LED
COLO
R
STATUS DESCRIPTION