ZyXEL Communications P-660HN-F1A, User Manual

Page: 179 / 430

Chapter 9 Network Address Translation (NAT)
P-660HN-F1A User’s Guide
179
9.3.2 The Port Forwarding Rule Edit Screen
Use this screen to edit a port forwarding rule. Click the rule’s edit icon in the Port
Forwarding screen to display the screen shown next.
Figure 68 Network > NAT > Port Forwarding: Edit
The following table describes the fields in this screen.
9.4 The Address Mapping Screen
Note: The Address Mapping screen is available only when you select Full Feature
in the NAT > General screen.
Table 46 Network > NAT > Port Forwarding: Edit
LABEL DESCRIPTION
Active Click this check box to enable the rule.
Service Name Enter a name to identify this port-forwarding rule.
Start Port
Enter a port number in this field.
To forward only one port, enter the port number again in the End Port
field.
To forward a series of ports, enter the start port number here and the end
port number in the End Port field.
End Port Enter a port number in this field.
To forward only one port, enter the port number again in the Start Port
field above and then enter it again in this field.
To forward a series of ports, enter the last port number in a series that
begins with the port number in the Start Port field above.
Server IP
Address Enter the inside IP address of the server here.
Back Click this to return to the previous screen without saving.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.