ZyXEL Communications P-660HN-F1A, User Manual

Page: 152 / 430

Chapter 8 Wireless LAN
P-660HN-F1A User’s Guide
152
The following table describes the labels in this screen.
8.3 The More AP Screen
This screen allows you to enable and configure multiple Basic Service Sets (BSSs)
on the P-660HN-F1A.
Click Network > Wireless LAN > More AP. The following screen displays.
Figure 52 Network > Wireless LAN > More AP
Table 35 Network > Wireless LAN > AP: Advanced Setup
LABEL DESCRIPTION
RTS/CTS
Threshold Enter a value between 0 and 2432.
Fragmentation
Threshold This is the maximum data fragment size that can be sent. Enter a value
between 256 and 2432.
Output Power Set the output power of the P-660HN-F1A. If there is a high density of
APs in an area, decrease the output power to reduce interference with
other APs. Select one of the following Maximum, Middle or Minimum.
Preamble Select a preamble type from the drop-down list menu. Choices are Long,
Short or Dynamic. The default setting is Long. See the appendix for
more information.
802.11 Mode Select 802.11bg to allow either IEEE 802.11b or IEEE 802.11g compliant
WLAN devices to associate with the P-660HN-F1A. The transmission rate
of your P-660HN-F1A might be reduced.
Select 802.11b/g/n to allow IEEE 802.11b, IEEE 802.11g, or IEEE
802.11n compliant WLAN devices to associate with the P-660HN-F1A.
The transmission rate of your P-660HN-F1A might be reduced.
Back Click this to return to the previous screen without saving.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.