ZyXEL Communications P-660HN-F1A, User Manual

Page: 129 / 430

Chapter 7 LAN Setup
P-660HN-F1A User’s Guide
129
Finding Out More
See Section 7.6 on page 137 for technical background information on LANs.
7.1.3 Before You Begin
Find out the MAC addresses of your network devices if you intend to add them to
the DHCP Client List screen.
7.2 The LAN IP Screen
Use this screen to set the Local Area Network IP address and subnet mask of your
P-660HN-F1A. Click Network > LAN to open the IP screen.
Follow these steps to configure your LAN settings.
1
Enter an IP address into the IP Address field. The IP address must be in dotted
decimal notation. This will become the IP address of your P-660HN-F1A.
2
Enter the IP subnet mask into the IP Subnet Mask field. Unless instructed
otherwise it is best to leave this alone, the configurator will automatically compute
a subnet mask based upon the IP address you entered.
3
Click Apply to save your settings.
Figure 39 Network > LAN > IP
The following table describes the fields in this screen.
Table 25 Network > LAN > IP
LABEL DESCRIPTION
IP Address Enter the LAN IP address you want to assign to your P-660HN-F1A in
dotted decimal notation, for example, 192.168.1.1 (factory default).
IP Subnet Mask Type the subnet mask of your network in dotted decimal notation, for
example 255.255.255.0 (factory default). Your P-660HN-F1A
automatically computes the subnet mask based on the IP Address you
enter, so do not change this field unless you are instructed to do so.