ZyXEL Communications P-660H-T1 v3s, User Manual

Page: 34 / 272

Chapter 3 Status Screens
P-660H-T1v3s User’s Guide
34
Each field is described in the following table.
Table 4 Status Screen
LABEL DESCRIPTION
Refresh Interval Select how often you want the P-660H-T1v3s to update this screen.
Apply
Click this to update this screen immediately.
Device Information
Host Name This field displays the P-660H-T1v3s system name. It is used for
identification. You can change this in the Maintenance > System >
General screen’s System Name field.
Model
Number
This is the model name of your device.
MAC
Address
This is the MAC (Media Access Control) or Ethernet address unique to
your P-660H-T1v3s.
ZyNOS
Firmware
Version
This is the current version of the firmware inside the device. It also
shows the date the firmware version was created. Click this to go to the
screen where you can change it.
DSL
Firmware
Version
This is the current version of the device’s DSL modem code.
WAN
Information
DSL Mode This is the DSL standard that your P-660H-T1v3s is using.
IP Address This is the current IP address of the P-660H-T1v3s in the WAN. Click
this to go to the screen where you can change it.
IP Subnet
Mask
This is the current subnet mask in the WAN.
Default
Gateway
This is the IP address of the default gateway, if applicable.
VPI/VCI This is the Virtual Path Identifier and Virtual Channel Identifier that you
entered in the wizard or WAN screen.
LAN
Information
IP Address This is the current IP address of the P-660H-T1v3s in the LAN. Click this
to go to the screen where you can change it.
IP Subnet
Mask
This is the current subnet mask in the LAN.
DHCP This field displays what DHCP services the P-660H-T1v3s is providing to
the LAN. Choices are:
Server - The P-660H-T1v3s is a DHCP server in the LAN. It assigns IP
addresses to other computers in the LAN.
Relay - The P-660H-T1v3s acts as a surrogate DHCP server and relays
DHCP requests and responses between the remote server and the
clients.
None - The P-660H-T1v3s is not providing any DHCP services to the
LAN.
Click this to go to the screen where you can change it.