ZyXEL Communications P-660H-T1 v3s, User Manual

Page: 133 / 272

Chapter 11 Static Route
P-660H-T1v3s User’s Guide
133
11.2.1 Static Route Edit
Use this screen to configure the required information for a static route. Select a
static route index number and click Edit. The screen shown next appears.
Figure 52 Advanced > Static Route: Edit
The following table describes the labels in this screen.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.
Table 34 Advanced > Static Route
LABEL DESCRIPTION
Table 35 Advanced > Static Route: Edit
LABEL DESCRIPTION
Destination IP
Address This parameter specifies the IP network address of the final destination.
Routing is always based on network number. If you need to specify a
route to a single host, use a subnet mask of 255.255.255.255 in the
subnet mask field to force the network number to be identical to the host
ID.
IP Subnet
Mask Enter the IP subnet mask here.
Gateway Type Use either Gateway Address or Gateway Node to configure a static
route.
Gateway IP
Address This field is available when you select Gateway Address from Gateway
Type.
Enter the IP address of the gateway. The gateway is a router or switch on
the same network segment as the device's LAN or WAN port. The
gateway helps forward packets to their destinations.
Back Click this to return to the previous screen without saving.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.