ZyXEL Communications P-2802H-I Series, User Manual

Page: 111 / 418

Chapter 8 Wireless LAN
P-2802H(W)(L)-I Series User’s Guide
111
The following table describes the labels in this screen.
8.5 OTIST Screen
Use this screen to set up and start OTIST on the ZyXEL Device in your wireless network. To
open this screen, click
Network > Wireless LAN > OTIST .
Figure 55 Network > Wireless LAN > OTIST
Table 35 Wireless LAN: Advanced
LABEL DESCRIPTION
Wireless Advanced Setup
RTS/CTS
Threshold
Enter a value between 0 and 2432.
Fragmentation
Threshold
It is the maximum data fragment size that can be sent. Enter a value between 256
and 2432.
Preamble Select a preamble type from the drop-down list menu. Choices are Long , Short or
Dynamic . The default setting is Long . See the appendix for more information.
802.11 Mode Select 802.11b Only to allow only IEEE 802.11b compliant WLAN devices to
associate with the ZyXEL Device.
Select
802.11g Only to allow only IEEE 802.11g compliant WLAN devices to
associate with the ZyXEL Device.
Select
Mixed to allow either IEEE 802.11b or IEEE 802.11g compliant WLAN devices
to associate with the ZyXEL Device. The transmission rate of your ZyXEL Device
might be reduced.
Back Click this to return to the previous screen without saving changes.
Apply Click Apply to save your changes back to the ZyXEL Device.
Cancel Click Cancel to reload the previous configuration for this screen.