ZyXEL Communications P-2612HW-F1 -, User Manual

Page: 152 / 547

Chapter 8 Wireless LAN
P-2612HW Series User’s Guide
152
8.5 WPS
Use this screen to configure WiFi Protected Setup (WPS) on your ZyXEL Device.
WPS allows you to quickly set up a wireless network with strong security, without
having to configure security settings manually. Set up each WPS connection
between two devices. Both devices must support WPS. See
Appendix D on page
507 for more information about WPS.
Click Network > Wireless LAN >WPS. The following screen displays.
Figure 100 Network > Wireless LAN > WPS
The following table describes the labels in this screen.
MAC
Address Enter the MAC addresses of the wireless devices that are allowed or denied
access to the ZyXEL Device in these address fields. Enter the MAC
addresses in a valid MAC address format, that is, six hexadecimal character
pairs, for example, 12:34:56:78:9a:bc.
Apply Click Apply to save your changes back to the ZyXEL Device.
Cancel Click Cancel to reload the previous configuration for this screen.
Table 37 Network > Wireless LAN > MAC Filter
LABEL DESCRIPTION
Table 38 Network > Wireless LAN > WPS
LABEL DESCRIPTION
WPS Setup
Enable WPS
Select the check box to activate WPS on the ZyXEL Device.
PIN Number This shows the PIN (Personal Identification Number) of the ZyXEL
Device. Enter this PIN in the configuration utility of the device you want
to connect to using WPS.
The PIN is not necessary when you use WPS push-button method.