ZyXEL Communications P-2608HWL-D1, User Manual

Page: 76 / 451

P-2608HWL-Dx Series User’s Guide
76 Chapter 5 Bandwidth Management Wizard
Figure 38 Bandwidth Management Wizard: Service Configuration
The following table describes the labels in this screen.
Table 18 Bandwidth Management Wizard: Service Configuration
LABEL DESCRIPTION
Active Select Active to enable bandwidth management for service specified traffic.
Select an entry’s Active check box to turn on bandwidth management for the service/
application.
Service These fields display the services names.
Priority Select High , Mid or Low priority for each service to have your ZyXEL Device use a
priority for traffic that matches that service.
A service with
High priority is given as much bandwidth as it needs.
If you select services as having the same priority, then bandwidth is divided equally
amongst those services.
Services not specified in bandwidth management are allocated bandwidth after all
specified services receive their bandwidth requirements.
If the rules set up in this wizard are changed in
Advanced , Bandwidth MGMT , Rule
Setup , then the service priority radio button will be set to User Configured .
The Advanced , Bandwidth MGMT , Rule Setup screen allows you to edit these rule
configurations.
Back Click Back to go back to the previous wizard screen.
Apply Click Apply to save your changes back to the ZyXEL Device.
Exit Click Exit to close the wizard screen without saving your changes.