ZyXEL Communications P-2602HWLNI, User Manual, Page: 414 / 496

Chapter 29 Tools
P-2602HWLNI User’s Guide
414
computer and renames it “
config.rom
”. See earlier in this chapter for more
information on filename conventions.
7 Enter “
quit
” to exit the ftp prompt.
29.7.2 FTP Command Configuration Backup Example
This figure gives an example of using FTP commands from the DOS command prompt to save
your device’s configuration onto your computer.
Figure 244 FTP Session Example
29.7.3 Configuration Backup Using GUI-based FTP Clients
The following table describes some of the commands that you may see in GUI-based FTP
clients.
29.7.4 Backup Configuration Using TFTP
The ZyXEL Device supports the up/downloading of the firmware and the configuration file
using TFTP (Trivial File Transfer Protocol) over LAN. Although TFTP should work over
WAN as well, it is not recommended.
To use TFTP, your computer must have both telnet and TFTP clients. To backup the
configuration file, follow the procedure shown next.
331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> get rom-0 zyxel.rom
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 16384 bytes sent in 1.10Seconds 297.89Kbytes/sec.
ftp> quit
Table 179 General Commands for GUI-based FTP Clients
COMMAND DESCRIPTION
Host Address Enter the address of the host server.
Login Type Anonymous.
This is when a user I.D. and password is automatically supplied to the
server for anonymous access. Anonymous logins will work only if your
ISP or service administrator has enabled this option.
Normal.
The server requires a unique User ID and Password to login.
Transfer Type Transfer files in either ASCII (plain text format) or in binary mode.
Initial Remote Directory Specify the default remote directory (path).
Initial Local Directory Specify the default local directory (path).