ZyXEL Communications OMC-2301, User Manual

Page: 81 / 224

Chapter 7 Classifier Filter Profile
OMC-2301 User’s Guide
81
7.2.1 Example: Classifier Filter Profile
The following example sets the ONU to forwards all untagged packets and drops all tagged
packets from the OLT. The ONU drops outgoing packets with VLAN ID 10 to the OLT.
Figure 26 Classifier Filter Profile: Example
Value Enter the packet type value to check.
For VLAN filter rules, enter a VID (1-4094).
If you select
Ethertype in the Filter Rules field, enter the Ethernet type number in
hexadecimal value (0x0000 - 0xff0f). The 0x prefix is already entered for you. Refer to
Table 25 on page 95 for common Ethernet type numbers.
If you select IPv4 Protocol in the Filter Rules field, enter an IPv4 protocol number (1-
255). Refer to Table 26 on page 96 for common protocol numbers.
If you select Src TCP Port or Src UDP Port in the Filter Rules field, enter a TCP
service port number (1 - 65535).
If you select
Src IP Address in the Filter Rules field, enter a source IP address in
dotted decimal notation. For example, 192.168.1.10.
If you select
Dest IP Address in the Filter Rules field, enter a destination IP address
in dotted decimal notation. For example, 192.168.1.10.
Action Select whether to drop ( Discard ) or forward ( Pass ) the classified packets.
Add After you set the fields above, click Add to insert a new rule.
Cancel Click Cancel to reset the fields.
Clear Click Clear to begin configuring this screen afresh.
Name This field displays the name of a profile. Click a name to configure the profile.
Active This field displays whether the profile is enabled or not.
Delete Select the entry(ies) that you want to remove in the Delete column and then click the
Delete button.
Cancel Click Cancel to clear the Delete check boxes.
Table 19 Classifier Filter Profile Setup (continued)
LABEL DESCRIPTION