ZyXEL Communications OMC-2301, User Manual

Page: 62 / 224

Chapter 6 Basic Setting
OMC-2301 User’s Guide
62
6.5 Port Setup
Use the Port Setup screen to configure the uplink ports. Click Basic Setting > Port Setup in
the navigation panel to display the configuration screen.
Figure 19 Port Setup
The following table describes the labels in this screen.
Apply Click Apply to save the settings.
Cancel Click Cancel to reset the fields to your previous configuration.
Table 13 IP Setup (continued)
LABEL DESCRIPTION
Table 14 Port Setup
LABEL DESCRIPTION
Uplink Port This is the uplink port index number.
The digit(s) before 0 in a port number corresponds to the card slot on the OLT, and the
last digit denotes the port type (1 for PON port and 2 for uplink port).
Active Select this check box to enable a port. The factory default for all ports is enabled. A
port must be enabled for data transmission to occur.
Name Enter a descriptive name (up to nine printable characters and spaces allowed) that
identifies this port.
Speed/Duplex This field displays 1000M/Full Duplex .
Note: The Gigabit Ethernet ports connect at 1000 Mbps only. Connect
only Gigabit Ethernet devices to these ports.