Chapter 41 RIP
OLT2406 User’s Guide
331
41.2 Configuring RIP
Click
IP Application
>
RIP
in the navigation panel to display the screen as shown. You cannot manually
configure a new entry. Each entry in the table is automatically created when you configure a new IP
domain in the
IP Setup
).
Figure 202
IP Application > RIP
The following table describes the labels in this screen.
Table 151 IP Application > RIP
LABEL
DESCRIPTION
Active
Select this check box to enable RIP on the OLT.
Distance
Enter a number from 10 to 255 to specify the administrative distance that is assigned to routes
learned by RIP.
The lower the administrative distance value is, the more preferable the routing protocol is. See
for more information about administrative distance.
Note: You cannot set two routing protocols to have the same administrative distance.
Index
This field displays the index number of an IP interface.
Network
This field displays the IP interface configured on the OLT.
Refer to the section on IP Setup for more information on configuring IP domains.
Direction
Select the RIP direction from the drop-down list box. Choices are
Outgoing
,
Incoming
,
Both
and
None
.
Version
Select the RIP version from the drop-down list box. Choices are
RIP-1
,
RIP-2B
and
RIP-2M
.
Apply
Click
Apply
to save your changes to the OLT’s run-time memory. The OLT loses these changes if it is
turned off or loses power, so use the
Save
link on the top navigation panel to save your changes to
the non-volatile memory when you are done configuring.
Cancel
Click
Cancel
to begin configuring this screen afresh.
Summary of Contents for OLT2406
