ZyXEL Communications OLT-1308, User Manual, Page: 53 / 314

Chapter 4 The Web Configurator
OLT-1308 Series User’s Guide
53
To upload the configuration file, do the following:
1 Connect to the console port using a computer with terminal emulation software. See
Section 3.1.4 on page 41 for details.
2 Disconnect and reconnect the OLT’s power to begin a session. When you reconnect the
OLT’s power, you will see the initial screen.
3 When you see the message “
Press any key to enter Debug Mode within 3
seconds ...
” press any key to enter debug mode.
4 Type
atlc
after the “
Enter Debug Mode
” message.
5 Wait for the “
Starting XMODEM upload
” message before activating XMODEM
upload on your terminal.
6 After a configuration file upload, type
atgo
to restart the OLT.
Figure 14 Resetting the Device: Via the Console Port
The OLT is now reinitialized with a default configuration file including the default
administrator login password of
1234 and the out-of-band management IP address of
192.168.0.1 .
4.6 Logging Out of the Web Configurator
Click Logout in a screen to exit the web configurator. You have to log in with your password
again after you log out. This is recommended after you finish a management session for
security reasons.
Figure 15 Web Configurator: Logout Screen
Bootbase Version: VAIJ100 | 04/13/2006 18:25:19
RAM:Size = 64 Mbytes
FLASH: Intel 64M
ZyNOS Version: V3.60(AIJ.0) | 05/10/2006 18:10:56
Press any key to enter debug mode within 3 seconds.
....................
Enter Debug Mode
sysname> atlc
Starting XMODEM upload (CRC mode)....
CCCCCCCCCCCCCCCC
Total 393216 bytes received.
Erasing..
................................................................
OK
sysname> atgo