ZyXEL Communications OLT-1308, User Manual, Page: 281 / 314

Chapter 38 Command Examples
OLT-1308 Series User’s Guide
281
• Remove the remote host with IP address 172.165.1.9 and with an SSH-RSA encryption
key from the list of known hosts.
38.9 priority-profile Commands
This section shows you how to configure a priority profile with a layer 2 priority rule. This
profile also sets the VLAN priority and assigns specified packets to queues.
Syntax:
priority-profile <name>
priority-profile <name> active
priority-profile <name> l2-rule <1-8> classifier <ethertype|ipv4|vlan>
priority-profile <name> l2-rule <1-8> direction <downstream|upstream>
priority-profile <name> l2-rule <1-8> queue <0-3>
priority-profile <name> l2-rule <1-8> value <ethertype <0-65295>|vlan <1-
4094>>
priority-profile <name> l2-rule <1-8> vlan-priority <0-7>
where
Use these commands to create and configure a priority profile.
sysname(config)# no ssh key rsa1
sysname(config)# no ssh known-hosts 172.165.1.8
sysname(config)# no ssh known-hosts 172.165.1.9 ssh-rsa
<name>
= Creates a new priority profile or edits an exiting priority
profile.
active
= Enables the priority profile.
classifier
<ethertype|ipv4|vlan>
= Specifies the classifier type.
direction
<downstream|upstream>
= Specifies the direction of the traffic to which the priority rule
settings apply.
queue <0-3>
= Assigns a queue to the matched packets.
value <ethertype <0-
65295>|vlan <1-4094>>
= Specifies the packet type.
For
ethertype
classifier, enter the Ethernet type number in
hexadecimal value (0x0000 - 0xff0f).
For
vlan
classifier, enter a VID (between 1 and 4094).
vlan-priority <0-7>
= Sets the VLAN priority in VLAN packet header. This
ensures quality of service between multiple switching/
routing devices on the network and allows flexible
prioritization. Enter a number between 0 and 7. The bigger
the number, the higher the priority.
tos-to-cos tos <0-7>
cos <0-7>
= Sets the TOS-COS mapping.