ZyXEL Communications OLT-1308, User Manual, Page: 276 / 314

Chapter 38 Command Examples
OLT-1308 Series User’s Guide
276
This command displays information about the route to an Ethernet device. The following
example displays route information to an Ethernet device with an IP address of
192.168.1.100
.
38.5 epon-common Commands
This section shows you how to configure common EPON settings in configuration mode.
Syntax:
epon-common dba-mode <plato>
epon-common igmp-last-member
epon-common igmp-last-mem-query-count <1-16>
epon-common igmp-last-mem-query-interval <1-13>
epon-common igmp-snooping
epon-common igmp-query-timeout-count <1-16>
Where
Use these commands to set common EPON settings on the OLT and ONU.
[wait <1-60>] =
Specifies the time period to wait.
[quesries <1-10>] =
Specifies how many tries the OLT performs the traceroute
function.
sysname> traceroute 192.168.0.100
traceroute to 192.168.0.100, 30 hops max, 40 byte packet
1:192.168.0.100 (10 ms) (10 ms) (0 ms)
traceroute done:
sysname>
dba-mode <plato> =
Sets the dynamic bandwidth allocation mode to use on the
device during network congestion. For Plato DBA, the device
assigns unused bandwidth based on various criteria
(bandwidth settings, priority and delay tolerance).
igmp-last-member =
Sets the ONU to query all group members when a group leave
message is received. This is to confirm that all group members
wish to leave that IGMP group.
igmp-last-mem-
query-count <1-
16> =
Sets the number of times the ONU sends a group-leave query.
igmp-last-mem-
query-interval
<1-13> =
Sets the number of seconds the ONU waits for the report in
response to a group-leave query.
igmp-snooping =
Enables IGMP snooping on the ONU.
igmp-query-
timeout-count <1-
16> =
Sets a query timeout count. When the ONU snoops the first
query, it starts the count down. For each query the ONU
snoops, this timeout count is decreased by 1. When this
number reaches zero, a group member is removed from the
group if no report message is received.