Chapter 19 IP Configuration
NetAtlas Workgroup User’s Guide
214
Figure 157
IP Configuration: OSPF: New OSPF Setting
The following table describes the related labels in this screen.
19.8.5 Configuring a New OSPF Virtual Link
Follow the steps below to create a new OSPF virtual link.
1
In the Device Panel list, right-click on a device.
2
Click
Configuration > IP Configuration > OSPF
.
3
Click
Add
in the
Virtual Link
pane.
Table 119
IP Configuration: OSPF: New OSPF Setting
LABEL
DESCRIPTION
Name
Enter a descriptive name (up to 32 printable ASCII characters) for identification
purposes.
Area ID
Enter a 32-bit ID (that uses the format of an IP address in dotted decimal notation) that
uniquely identifies an area.
A value of
0.0.0.0
indicates that this is a backbone (also known as Area 0). You can
create only one backbone area on the switch.
Authentication Select
an
authentication method (
Simple
or
MD5
) to activate authentication. Select
None
to disable authentication.
Interface(s) and virtual interface(s) must use the same authentication method as the
associated area.
Stub Network
Select this option to set the area as a stub area.
If you enter
0.0.0.0
in the
Area ID
field, the settings in the
Stub Network
fields are
ignored.
No Summary
Select this option to set the switch to not send/receive LSAs.
Default Route
Cost
Specify a cost (between 0 and 16777214) used to add a default route into a stub area
for routes which are external to an OSPF domain. If you do not set a route cost, no
default route is added.
Add
Click
Add
to apply the changes and close this screen.
Cancel Click
Cancel
to discard all changes and close this screen.
Summary of Contents for NetAtlas Workgroup
