ZyXEL Communications NBG-418N v2, User Manual, Page: 69 / 228

Chapter 6 Wireless LAN
NBG-418N v2 User’s Guide
69
The following table describes the labels in this menu.
6.6 Wireless LAN Advanced Screen
Use this screen to allow intra-BSS networking and set the RTS/CTS Threshold.
Click Network > Wireless LAN > Advanced . The screen appears as shown.
Figure 47
Network > Wireless LAN > Advanced (Universal Repeater Mode)
The following table describes the labels in this screen.
Table 21
Network > Wireless LAN > MAC Filter
LABEL DESCRIPTION
Active Click Active check box to enable MAC address filtering.
MAC Address
(White List) This field shows the MAC addresses of the wireless station that are allowed or denied access
to the NBG-418N v2 in these address fields. Enter the MAC addresses in a valid MAC address
format, that is, six hexadecimal character pairs, for example, 12:34:56:78:9a:bc.
Select Click the Select radio button to select a MAC filter entry.
Delete Click the Delete button to delete the selected MAC filter entry.
Delete All Click the Delete All button to remove all MAC filter entries.
MAC Address Enter the MAC addresses of the wireless station that are allowed or denied access to the
NBG-418N v2 in these address fields. Enter the MAC addresses in a valid MAC address
format, that is, six hexadecimal character pairs, for example, 12:34:56:78:9a:bc.
Add Click Add to add a new MAC address to the MAC Filtering rule.
Apply Click Apply to save your changes back to the NBG-418N v2.
Reset Click Reset to reload the previous configuration for this screen.
Table 22
Network > Wireless LAN > Advanced (Universal Repeater Mode)
LABEL DESCRIPTION
Wireless Advanced Setup
Tx Power This field controls the transmission power of the NBG-418N v2. When using the NBG-
418N v2 with a notebook computer, select a transmission power level from the drop-
down list. Choose a lower transmission power level when you are close to the AP in order
to conserve battery power.