Chapter 4 Modes
NBG-418N v2 User’s Guide
37
2
The default LAN IP address of the NBG-418N v2 is 192.168.1.1 in router mode (192.168.1.2 by
default in non-router mode). In router mode, the NBG-418N v2 can assign your computer an IP
address, so you must set your computer to get an IP address automatically (computer factory
default) or give it a fixed IP address in the range between 192.168.1.3 and 192.168.1.254.
3
After you’ve set your computer’s IP address, open a web browser such as Internet Explorer and
type the IP address of the NBG-418N v2 as the web address in your web browser.
4
Log into the Web Configurator. See the
for instructions on how to do this.
5
Go to
Maintenance > Sys OP Mode > General
and select
Access Point
.
Figure 24
Maintenance > Sys OP Mode > AP
6
A pop-up window appears providing information on this mode. Click
OK
in the pop-up message
window. Click
Apply
. Your NBG-418N v2 is now in
AP Mode
.
Note: Wait while the NBG-418N v2 restarts, then log in to the Web Configurator again.
4.3.1 Status Screen (AP Mode)
Click on
Status
. The screen below shows the status screen in
AP Mode
.
Figure 25
Status Screen (AP Mode)
Summary of Contents for NBG-418N v2
Page 10: ...10 PART I User s Guide ...
Page 11: ...11 ...
Page 58: ...58 PART II Technical Reference ...
Page 59: ...59 ...