ZyXEL Communications NAS540, User Manual

Page: 79 / 372

Chapter 8 Storage Manager
Cloud Storage User’s Guide
79
8.3.6.3 S.M.A.R.T Attributes
The following table describes some common S.M.A.R.T. attributes. If a higher or lower raw attribute
value is better, it is indicated in the
BETTER column. Since S.M.A.R.T. attributes and their
definitions vary by manufacturer, refer to the hard drive manufacturer for details about the
attributes your hard drive supports.
Updated This indicates when the hard drive updates the value for this attribute.
• Always means the hard drive updates this attribute during normal operation and
during offline activities.
• Offline means the hard drive only updates this attribute when no one is accessing the
hard drive.
When Failed This column indicates when (if ever) the attribute failed. An attribute has failed if the
normalized value is less than or equal to the threshold.
• - : This displays if the attribute is not failing now and has never failed in the past.
• FAILING_NOW : This displays if the attribute’s current normalized value is less than or
equal to the threshold.
• In_the_past : This displays if the attribute’s current normalized value is greater than
the threshold but the worst recorded value is less than or equal to the threshold.
Raw Data This is the attribute’s unprocessed raw data. These values show exact amounts of time or
numbers of attempts or errors. The meaning to the raw values is specific to the hard drive
manufacturer. Table 42 on page 156 has some information about whether a higher or lower
individual raw S.M.A.R.T. attribute value is better.
Close Click this button to close the screen.
Table 20
S.M.A.R.T Info
LABEL DESCRIPTION
Table 21
S.M.A.R.T. Attributes
ID
ATTRIBUTE
NAME
BETTER DESCRIPTION
01 Read Error Rate Low Shows the rate of hardware read errors. If this is not zero, there is a
problem with the disk surface or the read/write heads.
02 Throughput
Performance High This is the hard drive’s general (overall) throughput performance. A
decreasing value indicates a problem.
03 Spin-Up Time Low This is the average number of milliseconds the hard drive took for spindle
spin up (from zero RPM to fully operational).
04 Start/Stop Count The total number of spindle start and stop cycles.
05 Reallocated
Sectors Count Low Total number of reallocated sectors on the hard drive. When the hard
drive detects a read/write/verification error, it marks the sector as
“reallocated” and transfers the data to a specially reserved (spare) area.
The process is also known as remapping with “reallocated” sectors known
as remaps. The more sectors the hard drive has to reallocate, the slower
read and write speeds become.
06 Read Channel
Margin This is the margin of a channel when it reads data.
07 Seek Error Rate Low This is the rate of the magnetic heads’ seek errors. A failure in the
mechanical positioning system, such as servo damage or a thermal
widening of the disk, results in seek errors. An increasing number of seek
errors indicate the condition of the disk surface and the mechanical
subsystem are worsening.
08 Seek Time
Performance High This is an average performance indicator for the seek operations of the
magnetic heads. Mechanical subsystem problems cause this value to
decrease.