ZyXEL Communications MSC1000G Series, User Manual

Page: 774 / 1168

Chapter 29 port Commands
Management Switch Card User’s Guide
774
set < slot-port >
< svid > < spriority >
< cvid > < cpriority >
Sets the double tagging settings on a port.
svid
: service provider VLAN ID, 0~4094
spri
: service provider VLAN priority, 0~7
cvid
: customer VLAN ID, 0~4094
cpri
: customer VLAN priority, 0~7
8
frametype < slot-port > <all|tag>
Sets the acceptable frame type on the port(s). 8
paepvc delete < slot-port-
vpi/vci >
Removes a PAE PVC (PPPoA-to-PPPoE PVC). 8
set < slot-port-vpi/
vci > llc|vcmux < pvid >
< priority > [acname
< acname >] [srvcname
< srvcname >]
[hellotime
< hellotime >]
Configures a PVC for PAE translation.
pvid
: private VLAN ID, 1~4094
priority
: IEEE 802.1p priority for traffic that
belongs to this VLAN, 0~7
acname
: The host name of the access concentrator,
length <=31.
srvcname :
A descriptive name for the service that
uses this PVC.
hellotime :
The timeout (0~600 seconds) for the
PPPoE session.
8
show < slot>| < slot-
port >|< slot-port-
vpi/vci >
Displays the PAEPVC settings for a slot, a port or a
PVC. 8
priority < slot-port >
< priority >
Sets the port(s)’ VLAN priority (0~7). 0 is the
lowest priority level and 7 is the highest. 8
pvc delete < slot-port-
vpi/vci >
Removes a PVC. 8
set < slot-port-vpi/
vci > llc|vcmux < pvid >
< priority >
Configures a PVC for subscribers using ATM-based
ADSL CPEs.
pvid
: private VLAN ID, 1~4094
priority
: IEEE 802.1p priority for traffic that
belongs to this VLAN, 0~7
8
show < slot>| < slot-
port >|< slot-port-
vpi/vci > [detail]
Displays the PVC settings for a slot, a port or a
PVC. If
detail
is specified, you can also see the
VLAN information.
1
pvid < slot-port > < vid >
Sets the port VID on the port(s). 8
pvlan delete < slot-port >
< etype >
Deletes a protocol VLAN setting on a specified port. 8
set < slot-port >
< etype > < vid >
< priority >
Sets the protocol VLAN settings on a specified port. 8
qratelimit <slot-port> <profile>
Assigns a profile of per-queue rate limiting
parameters to the specified port. 8
Table 364
port Commands (continued)
COMMAND DESCRIPTION P