ZyXEL Communications MSC1000G Series, User Manual

Page: 732 / 1168

Chapter 27 lcman Commands
Management Switch Card User’s Guide
732
This command turns off the management of the specified line card. This command is for
troubleshooting.
The system can automatically restart a line card that it is managing. If a line card is unresponsive
and the
lcman reset
command does not help, you may need to use
lcman disable
before
connecting to the line card’s console port and recovering the firmware. Do this to keep the system
from turning the line card off during your firmware recovery.
The following example turns off the line card in slot 7.
27.2.3 lcman reset Command
Syntax:
lcman reset < slot >
This command performs a hardware reset on the specified line card. You can use this on an
unresponsive line card.
Note: The system will not apply this command if the line card is upgrading firmware.
The following example resets the line card in slot 7.
27.2.4 lcman show Command
Syntax:
lcman show [< slot >]
This command displays information about the line cards in the system. This information includes
how many slots are under management, and the type of line card the MSC is managing in each slot
(if any), as well as the line card’s uptime, firmware version and any alarms.
The following example shows an overview of all of the cards that are installed in the system’s slots.
ras> lcman disable 7
ras> lcman reset 7
ras> lcman show
id state card type uptime f/w version heat vol mon down out
-- -------- ----------- ------------- ------------------- ---------------------
1 standby MSC1000G 01:36:48 V3.70(LU.0) - - - - -
2 active MSC1000G 23:45:55 V3.70(LU.0) - - - - -
3 - - - - - -
4 - ALC1248G-53 V3.70(ABE.0) - - - V V
5 active ALC1248G-53 22:45:41 V3.53(ABE.0) - - - - -
6 - - - - - -
7 - ALC1248G-51 V3.70(ABD.0) - - - V V
8 - - - - - -
9 - ALC1248G-53 V3.53(ABE.0) - - - V V
10 - ALC1248G-53 V3.53(ABE.0) - - - V V