ZyXEL Communications MSC1000G Series, User Manual

Page: 726 / 1168

Chapter 25 ip Commands
Management Switch Card User’s Guide
726
Note: Use the out-of-band management port or console port to configure the system if
you misconfigure the management VLAN and lock yourself out from performing in-
band management.
Note: It is highly recommended that you use the
sys reboot < seconds
> command
before using any command that may lock yourself out from performing device
management. Use the
sys reboot cancel
command to cancel the scheduled
rebooting before time is up when you are sure that you had the correct
configuration.
1
Use the
vlan set
command to configure a VLAN ID (VID 3 in this example) for managing the
system (the “management” or “CPU” VLAN).
2
Use the
ip set
command to set VID 3 as the management VLAN.
25.2.10 ip tracert Command
Syntax:
ras> ip tracert < ip-address >
This command sends a traceroute packet to the IP address (in the field to the left) and uses the
response to determine the path a packet takes to that IP address.
The following example displays route information to an Ethernet device with an IP address of
123.23.19.11.
ras> vlan set 3 up1 fix tag
ras> vlan enable 3
ras> ip set inband 192.168.1.2 3
ras> ip tracert 123.23.19.11
Resolving 123.23.19.11... traceroute to 123.23.19.11 (123.23.19.11), 30 hops
max
, 40 byte packet
1:123.23.14.254 (0 ms) (0 ms) (0 ms)
2:123.23.19.11 (0 ms) (0 ms) (0 ms)
traceroute done: